Safety Data Sheet NAIL POLISH REMOVER PADS. Phone Emergency Phone Fax (800) (800) (847) CHEMTREC CHEMTREC

Transcription

1 Section 1. Identification Safety Data Sheet NAIL POLISH REMOVER PADS Product Identifier Synonyms Manufacturer Stock Numbers NAIL POLISH REMOVER PADS MDS MDS Recommended use Uses advised against For removing nail polish. Apply sterile lubricating gel to instrument or skin. Manufacturer Contact Address Medline Industries, Inc. 3 Lakes Drive Northfield, IL, USA Phone Emergency Phone Fax (800) (800) (847) CHEMTREC CHEMTREC Website Section 2. Hazards Identification Classification Signal Word Pictogram Hazard Statements Precautionary Statements Response Prevention Storage No OSHA Hazard Classifications Applicable - Category No OSHA Hazard Classifications Applicable Page 1 of 5

2 Disposal Ingredients of unknown toxicity 0% Hazards not Otherwise Classified Potential Health Effects: Eyes May cause slight temporary eye irritation. Corneal injury is highly unlikely. Skin Prolonged contact may cause slight skin irritation with local redness. Skin absorption Prolonged skin contact is unlikely to result in absorption of harmful amounts. Prolonged/repeated exposure to damaged skin (as in burn patients) may result in absorption of toxic amounts. Ingestion Very low toxicity if swallowed. Harmful effects not anticipated from swallowing small amounts. Inhalation At room temperature, exposure to vapor is minimal due to low volatility; single exposure is not likely to be hazardous. For respiratory irritation and narcotic effects: No relevant data found. Section 3. Ingredients CAS Ingredient Name Weight % Acetic acid, methyl ester 40 % Ethanol, 2-methoxy % Ethanol, 2-(2-butoxyethoxy)- 20 % ,3-Propanediol, 2-methyl- 1 % ,2,3-Propanetricarboxylic acid, 2-hydroxy-, trisodium salt 0.01 % Benzenemethanaminium, N-[2-[(2,6-dimethylphenyl)amino]-2-oxoethyl]-N,N-diethyl-, 0.01 % H-1-Benzopyran-6-ol, 3,4-dihydro-2,5,7,8-tetramethyl-2-(4,8,12-trimethyltridecy % Occupational exposure limits, if available, are listed in Section 8. Section 4. First-Aid Measures Eye Contact Skin Contact Inhalation Ingestion Flush eyes with water and continue washing for 15 minutes. Remove contact lenses if worn. If needed, obtain medical attention. If irritation occurs, stop using the wipe. If irritation occurs, stop using the wipe. Remove person to fresh air. Induce vomiting, obtain immediate medical attention. Section 5. Fire Fighting Measures Page 2 of 5

3 Suitable Extinguishing Media Unsuitable Extinguishing Media Special Protective Equipment and Precautions for Fire-Fighters: Dry chemical, carbon dioxide, foam fog. Wear full protective clothing and self-contained breathing apparatus. Section 6. Accidental Release Measures Methods for Cleaning: Methods for Cleaning Up: Soak up liquid with inhert absorbent material. Sweep up and shovel into suitable containers for disposal. Section 7. Handling and Storage Handling Ventilation Storage Avoid contact with eyes. Use with adequate ventilation. General {mechanical} room ventilation is expected to be satisfactory where this product is stored and handled in closed equipment. Keep product in dry storage area at room temperature. Section 8. Exposure Controls/Personal Protection Occupational Exposure Limits Personal Protective Equipment Respiratory Protection Eye Ingredient Name ACGIH TLV OSHA PEL Acetic acid, methyl ester Ethanol, 2-methoxy- Ethanol, 2-(2-butoxyethoxy)- 1,3-Propanediol, 2-methyl- 1,2,3-Propanetricarboxylic acid, 2-hydroxy-, trisodium salt Benzenemethanaminium, N-[2-[(2,6- dimethylphenyl)amino]-2-oxoethyl]-n,n-diethyl-, 2H-1-Benzopyran-6-ol, 3,4-dihydro-2,5,7,8- tetramethyl-2-(4,8,12-trimethyltridecy Normal room ventilation is adequate. None normally required. Avoid direct eye contact. STEL Section 9. Physical and Chemical Properties Physical State Liquid absorbed Page 3 of 5

4 Color Odor Odor Threshold Solubility Partition coefficient Water/n-octanol VOC% Viscosity Specific Gravity Density lbs/gal Pounds per Cubic Foot Flash Point FP Method ph Melting Point Boiling Point Boiling Range LEL UEL Evaporation Rate Flammability Decomposition Temperature Auto-ignition Temperature Vapor Pressure Vapor Density onto non-woven Milky, Colorless Perfumed In all proportions. Section 10. Stability and Reactivity Stability No decomposition if stored and applied as directed. Section 11. Toxicological Information Toxicology Information The product contains no substances classified as hazardous to health in concentrations that should be taken into account. Section 12. Ecological Information Degradability This product is biodegradable apart from the pouch. This information is estimated on the basis of the MSDS of the raw materials contained in the product and/or of structurally comparable substances. Section 13. Disposal Page 4 of 5

5 Disposable Considerations If recycling is not practical, dispose of in compliance with local regulations. Section 14. Transport Information UN Number UN Proper Shipping Name DOT Classification Packing Group Not classified as dangerous in the transport regulations. Section 15. Regulatory Information Clean Air Act (CAA) Section 112, 112 (r): SARA 302: SARA 304: SARA 313: TSCA: CERCLA Hazardous Substance List: SARA 311/312: State Regulations: All components are listed or exempt. Refer to Section 2 of the SDS. New Jersey Dept. of Health RTK: Methyl Acetate Pennsylvania RTK: Methyl Acetate Rhode Island RTK: Methyl Acetate Massachusetts RTK: Methyl Acetate Section 16. Other Information Revision Date 1/22/2018 Legend Additional Information - Not Applicable N.E. - Not Established - Not Determined The information contained herein is furnished without warranty or legal responsibility of any kind. Employers should use this information only as a supplement to other information gathered by them and must make independent determination of suitability and completeness of information from all sources to assure proper use of these materials and the safety and health of employees Page 5 of 5