Page 1 of 5 Material Safety Data Sheet Infosafe No. SEPB4 Issue Date: March 2013 ISSUED by SEPTONE CS: 1.7.2 Product Name: SULLIT DEGREASER Not classified as hazardous 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND COMPANY/UNDERTAKING Product Name SULLIT DEGREASER Product Code ADSD20, ADSD200, ADSD1000 Product Use Degreaser and mine wash. Company Name Septone Products Pty Ltd (ABN 50 009 745 537) Address 44 Aquarium Avenue HEMMANT QLD 4174 Emergency Tel. Business hours only: 1800 000 945 or New Zealand Poisons Centre 0800 764 766 Telephone Tel: (07) 3390 5044 Number/Fax Fax: (07) 3390 5041 Email general@septone.com.au (For NZ customers other than in emergencies. Your supplier can be contacted) Other The information herein is, to the best of our knowledge, correct and complete. It describes the safety requirements for this product and should not be construed as guaranteeing specific properties. Since methods and conditions of application are beyond our control, Septone does not accept liability for any damages resulting from the use of, or reliance on, this information, in inappropriate contexts. 2. COMPOSITION/INFORMATION ON INGREDIENTS Chemical Liquid Characterization Ingredients Name CAS Proportion Hazard R Phrase Water 7732-18-5 60-100 % Ingredients determined not to be hazardous - 10-30 % Propanol, (2-34590-94-8 0-10 % methoxymethylethoxy)- 3. HAZARDS IDENTIFICATION Sensitization of Product Teratogenicity Safety Hazards No component of this product is considered to be a skin or respiratory sensitiser/. No component of this product is considered to be a teratogen. Spillages are slippery.
Page 2 of 5 Reproductive No component of this product is considered to be toxic to the Toxicity unborn foetus. Mutagenicity No component of this product is considered to be a mutagen. Carcinogenicity No component of this product is considered to be a carcinogen. Chronic Effects No known chronic effects. Inhalation Mildly irritating. At the recommended dilution rates, spray mists are unlikely to cause irritation. Ingestion Mildly irritating. irritant. Repeated or prolonged skin contact may lead to defatting of the skin, which can lead to the onset of dermatitis. Moderate eye irritant. 4. FIRST AID MEASURES Inhalation Ingestion First Aid Facilities Remove the victim from the source of exposure. If the victim is not breathing, apply artificial resuscitation. Do NOT induce vomiting. Give water to drink. Seek medical attention. Remove contaminated clothing and launder before re-use. Wash affected skin with soap and water. Hold the eyes open and flush with water for at least 15 minutes. Seek medical attention. An eye irrigation facility should be provided. This Material Safety Data Sheet should be provided to the attending medical doctor. Advice to Doctor Treat symptomatically. 5. FIRE FIGHTING MEASURES Extinguishing Use the extinguisher applicable to the source of the fire. Media Specific No special firefighting equipment required. Methods Specific Hazards None known. Flash Point This product will not flash and does not support combustion. Flammability This product is not flammable under the conditions of use and does not support combustion. 6. ACCIDENTAL RELEASE MEASURES Spills & Disposal Spillages are slippery. Personnel involved in cleaning up any spills are to wear rubber or PVC gloves and chemical goggles. Cordon off the spillage area. Isolate the source of the spillage or leak. For large amounts, contain the spillage using a suitable non-flammable absorbent material such as sand or diatomaceous earth, and then allow controlled access to the effluent system. For small amounts, wash the product to the drain with a large excess of water. 7. HANDLING AND STORAGE Store in plastic containers in a clean, dry, cool, well
Page 3 of 5 ventilated place away from foodstuffs. Handle the product appropriately and in accordance with industrial standards. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION National Exposure Standards Other Exposure Personal Protective Equipment Eng. Controls Name mg/m3 (STEL) ppm (STEL) mg/m3 (TWA) ppm (TWA) TWA Footnote Water - - - - Ingredients determined not to be hazardous - - - - Propanol, (2- methoxymethylethoxy)- 308 50 'skin' A 'skin' notation means that this substance may also be readily absorbed through the skin, which may be through direct contact or from exposure to very high atmospheric concentrations of vapour. The TLV is obviously invalidated if such contact should occur. The wearing of rubber or PVC gloves is highly recommended. The wearing of chemical goggles if handling large amounts or if splashing is likely to occur is highly recommended. Natural ventilation adequate under normal conditions of use. Keep containers closed when not in use. 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance Opaque pale blue viscous liquid, negligible odour. Boiling Point 100 C Solubility in Complete Water Specific Gravity 1.070 @ 25 C (H2O=1) ph Value 7.0 Evaporation As for Water Rate Volatile 83.2% w/w Component Flash Point This product will not flash and does not support combustion. Flammability This product is not flammable under the conditions of use and does not support combustion. 10. STABILITY AND REACTIVITY Stability Hazardous Polymerization Materials to Avoid Hazardous Decomposition Products Considered stable. No known conditions to avoid. Will not occur. Strong oxidising agents. During combustion, this product may produce carbon monoxide as well as other unidentifiable organic compounds.
Page 4 of 5 11. TOXICOLOGICAL INFORMATION Inhalation Ingestion Mildly irritating. At the recommended dilution rates, spray mists are unlikely to cause irritation. Mildly irritating. irritant. Repeated or prolonged skin contact may lead to defatting of the skin, which can lead to the onset of dermatitis. Moderate eye irritant. No known chronic effects. No component of this product is considered to be toxic to the unborn foetus. Chronic Effects Reproductive Toxicity Mutagenicity No component of this product is considered to be a mutagen. Carcinogenicity No component of this product is considered to be a carcinogen. 12. ECOLOGICAL INFORMATION on Ecological Effects The surfactants contained in this product are readily biodegradable when tested according to AS1792-1976 and are classified as biologically soft. None of the components of this product are known to bioaccumulate. When this product is released to the sewer at normal use levels as trade waste, the aquatic toxicity of the components is not considered to be high enough to cause adverse effects to aquatic organisms. This product contains approximately 1.7% phosphorus (in the form of STPP), which may lead to eutrophication of waterways. 2-methoxyethylethoxy propanol is not listed on the US EPA of hazardous air pollutants. 13. DISPOSAL CONSIDERATIONS 14. TRANSPORT INFORMATION IMO Marine Pollutant This product is classified as non dangerous according to the ACTDG. No component of this product is considered to be a marine pollutant. 15. REGULATORY INFORMATION Poisons Schedule AICS (Australia) Not Scheduled To the manufacturer's best knowledge, all components of this product are listed on AICS 16. OTHER INFORMATION Contact Person/Point Poisons Schedule Other Technical Manager (07) 3390 5044 Not Scheduled This product has been designed to comply with the NSW SRA
Page 5 of 5 requirements for quick break detergents. This quick break property means that emulsified grease and oil rapidly separate in a grease trap, allowing the resultant water layer to be drained to the sewer as treated trade waste....end Of MSDS... (C) Copyright ACOHS Pty Ltd Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. The compilation of MSDS's displayed is the intellectual property of Acohs Pty Ltd. Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express written consent of Acohs Pty Ltd.