INSTRUCTIONS
SHARE @INNOLUXEUK
INSTRUCTIONS FOR COLOUR Always mix your colour and developer before adding INNOluxe ReBond. Measure the amount of ReBond based on colour/bleach only, not colour/bleach and developer. FOR USE WITH BLEACH (OFF SCALP) 1. Raise your developer by one level: 1.1. If you normally use 20 vol, use 30 vol. 1.2. If you use 30 vol, use 40 vol. 1.3. (20 vol = 6%, 30 vol = 9%, 40 vol = 12%). 2. Mix your preferred bleaching powder or crème with developer following the guidance on step 1. Add ReBond in ratios of 6 ml per 30 g of bleach (1:5 ratio, not including the amount of developer). Once mixed, a little extra bleach powder can be added to achieve the desired consistency. 3. Apply and develop as usual. 4. Rinse hair, shampoo and apply Balance Plus for hair stabilisation. Comb through and leave for 10 minutes before rinsing. 5. Finish as required with Elixir and / or styling products.
FOR USE WITH BLEACH (ON SCALP) 1. Do not raise the level of the developer. 2. Mix your preferred bleaching powder or crème with developer. Add ReBond in ratios of 6 ml per 30 g of bleach (1:5 ratio, not including the amount of developer). A little extra bleach powder can be added to achieve the desired consistency. 3. Apply and develop as usual. 4. Rinse hair, shampoo and apply Balance Plus for hair stabilisation. Comb through and leave for 10 minutes before rinsing. 5. Finish as required with Elixir and / or styling products. FOR USE WITH TINTS (INCLUDING HIGH LIFT) 1. Mix your colour with your preferred developer. Do not raise the developer level. 2. Add 1 ml of ReBond for every 10 g of colour (not including the amount of developer). 3. Apply and develop as usual. 4. Rinse hair, shampoo and apply Balance Plus for hair stabilisation. Comb through and leave for 10 minutes before rinsing. 5. Finish as required with Elixir and / or styling products.
FOR USE WITH QUASI-PERMANENT COLOUR 1. Mix your colour with your preferred developer. Do not raise the developer level. 2. Add 1 ml of ReBond for every 10 g of Colour (not including the amount of developer). 3. Apply and develop as usual. 4. Rinse hair, shampoo (if required) and apply Balance Plus for hair stabilisation. Comb through and leave for 10 minutes before rinsing. 5. Finish as required with Elixir and / or styling products.
FOR USE WITH NON OXIDISING SEMI- PERMANENT COLOURS AND TONERS 1. Add 1 ml of ReBond for every 10 g of colour. 2. Apply and develop as usual. 3. Rinse hair and apply Balance Plus for hair stabilisation. Comb through and leave for 10 minutes before rinsing. 4. Finish as required with Elixir and / or styling products. FOR USE AS A STAND ALONE TREATMENT NEVER USE HIGHER QUANTITIES OF REBOND THAN THOSE INDICATED EXCESS REBOND MAY REDUCE THE EFFECTIVENESS OF THE BLEACH OR HAIR COLOUR
1. Cleanse twice with KeraStraight Pre-Treatment Cleanser (or any other gentle clarifying shampoo). Use a mild shampoo instead of Pre-Treatment Cleanser on very porous and fragile hair. Rinse and gently squeeze the moisture out. 2. Dilute ReBond with warm water in an applicator bottle in a ratio of 1 part ReBond to 6 parts water: 2.1. Short Hair 5 ml ReBond to 30 ml water. 2.2. Medium Hair - 10 ml ReBond to 60 ml water. 2.3. Long Hair 15 ml ReBond to 90 ml water. 3. Apply diluted ReBond throughout the hair (at the basin), saturating thoroughly. Leave on for 10 minutes. 4. Without rinsing, apply 10 ml Balance Plus. Comb through and leave for 10 minutes. 5. Rinse and style as required with Elixir and / or styling products.
FOR USE WITH KERASTRAIGHT 1. Cleanse twice with KeraStraight Pre-Treatment Cleanser, leave on for 5 minutes and cover with a cap if required. Rinse and gently squeeze the moisture out. 2. Dilute ReBond with warm water in an applicator bottle in a ratio of 1 part ReBond to 9 parts water: 2.1. Short Hair 5 ml ReBond to 45 ml water. 2.2. Medium Hair - 10 ml ReBond to 90 ml water. 2.3. Long Hair 15 ml ReBond to 135 ml water. 3. Apply diluted ReBond throughout the hair (at the basin), saturating thoroughly. Leave on for 10 minutes, before rinsing. 4. Gently towel dry, apply KeraStraight Pre-Treatment Spray Plus and KeraStraight as usual. FOR USE WITH RELAXERS 1. Add 3 ml of ReBond per 100 ml of ready mixed relaxer. 2. Apply and develop relaxer according to manufacturer s instructions. 3. Rinse hair, shampoo and apply Balance Plus (for hair stabilisation). Comb through and leave for 10 minutes before rinsing. 4. Finish as required with Elixir and / or styling products.
FOR USE WITH PERMS 1. Shampoo twice with pre-perm shampoo. 2. Towel dry gently. 3. Dilute ReBond with warm water in an applicator bottle in a ratio of 1 part ReBond to 6 parts water: 3.1. Short Hair 5 ml ReBond to 30 ml water. 3.2. Medium Hair - 10 ml ReBond to 60 ml water. 3.3. Long Hair 15 ml ReBond to 90 ml water. 4. Apply diluted ReBond throughout the hair (at the basin), saturating thoroughly. Leave on for 10 minutes. 5. Rinse and perm (following manufacturers instructions and timings). 6. Neutralise (following manufacturers instructions). 7. Repeat stage 3-4, applying ReBond mixture on to towel dried hair in the same measurements. 8. Without rinsing, apply 10 ml Balance Plus. Comb through and leave for 10 minutes. 9. Rinse and style as required with Elixir and / or styling products.
FOR USE WITH OTHER KERATIN SERVICES 1. Cleanse twice with prescribed clarifying shampoo, following manufacturers guidelines. Rinse and gently squeeze the moisture out. 2. Dilute ReBond with warm water in an applicator bottle in a ratio of 1 part ReBond to 9 parts water: 2.1. Short Hair 5 ml ReBond to 45 ml water. 2.2. Medium Hair - 10 ml ReBond to 90 ml water. 2.3. Long Hair 15 ml ReBond to 135 ml water. 3. Apply diluted ReBond throughout the hair (at the basin), saturating thoroughly. Leave on for 10 minutes, before rinsing. 4. Continue the Keratin Service (following manufacturers guidelines). REBOND MUST BE DILUTED BEFORE USING AS A STAND ALONE TREATMENT, WITH KERASTRAIGHT, PERMS AND OTHER KERATIN SERVICES
ELIXIR INNOluxe Elixir is a highly concentrated leavein conditioner that reinforces the hair s strength with multiple levels of flexible proteins. INNOluxe Elixir restores strength and flexibility, providing resistance to physical and environmental stresses. USING ELIXIR Apply 1-2 drops onto wet hair, apply styling product of choice and style as required.
SHARE @INNOLUXEUK +44 (0)3300 882226 WWW.INNOLUXE.COM