TILAB Ltd. FLAKE GLASS MATERIAL SAFETY DATA SHEET

Similar documents
: NEWAGE POWER CLEANER CONCENTRATE

Material Safety Data Sheet

PREPARE DATE : 09/24/2001 GENERAL INFORMATION: REVISION NO. : 0 DAP INC. : DAP-TIPS ( ) REVISION DATE: 09/24/2001

PREPARE DATE : 09/02/1997 GENERAL INFORMATION: REVISION NO. : 8 DAP INC. : DAP-TIPS ( ) REVISION DATE: 12/23/1999

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Vitamin D3 in Corn Oil

Material Safety Data Sheet

Surface Preparation or Protection

The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section.

Safety Data Sheet. 1. Identification. 2. Hazards Identification. 3. Composition/Information on Ingredients. Product Information: TV-4.

Woodsman Exterior Wood Cleaner

Date Printed: 5/19/2017 Product: M Surface Preparation or Protection

MATERIAL SAFETY DATA SHEET MSDS. Omni Filter Aid

ACGIH TLV mg/m3. OSHA PEL mg/m3

Safety Data Sheet DSC Products Inc. SDS#: 2236B Date Revised: 06/01/2015

Safety Data Sheet TREO - Vitreous Silicate Needled Blanket Insulation

MATERIAL SAFETY DATA SHEET

J. B. Jewitt Co., Inc. Homestead Finishing Products 1935 West 96 th Street Unit Q Cleveland OH Telephone: (216)

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet MSDS No: GB Page 1 of 5 ProForm BRAND Fiberglass Mesh Tape Date: December 27, 2010

4/30/2018 Product: S773 Axiom Clean Extraction Detergent. Axiom Clean Extraction Detergent

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

: DIAMOND-PLATE - 50 LB BAG

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET Page 1 of 5

MATERIAL SAFETY DATA SHEET

1. Chemical Product and Company Identification. 2. Composition and Information on Ingredients

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

WATERBORNE DYE CONCENTRATE YELLOW QT. Surface Preparation or Protection

Integrity Composites Material Safety Data Sheet MSDS # MSDS Date: June 2012

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Date Printed: 5/18/2018 Product: M Surface Preparation or Protection

5/22/2018 Product: B247 Axiom Clean Deodorizer

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

Chemical Name: Cold Weld. Manufacturer: JB Weld. Container size:.28oz. Location: VLA. Disposal: Place empty container in trash.

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

FILE NO.: DZEC04 NAME OF PRODUCT GlycoZoo Otic Cleanser DATE: 2/2/2018 INGREDIENT: CAS NO. % WT SARA 313 REPORTABLE

Fibrous Glass. Material Safety Data Sheet. Updated: 11/08. Quality You Can Trust Since From North America s Largest Roofing Manufacturer

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

SECTION 2 - GENERAL COMPOSITION OF TONER CONTAINED IN CARTRIDGE

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Safety Data Sheet. VEXTRA GLV, and GLVT SERIES Includes Series 1 P a g e WARNING 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Material Safety Data Sheet

*MATERIAL SAFETY DATA SHEET*

SAFETY DATA SHEET Page 1 of 5

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

ADVANCE CLEAN LIQUID DISHMACHINE DETERGENT

Z250 Z250 GREEN COLORING COMPOUND. CHEMICAL PRODUCT and COMPANY IDENTIFICATION

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET General Finishes Corporation. SECTION 2: Composition/Information on Ingredients

SAFETY DATA SHEET. SSS Re-Buff Buffing Cream

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET Gougeon Brothers, Inc.

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET KRC-7 CARPET Cleaner & Stain Remover SECTION 1 PRODUCT NAME AND COMPANY IDENTIFICATION

MATERIAL SAFETY DATA SHEET MSDS

Material Safety Data Sheet

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET FILE NO.: 106 SDS DATE: August 24, 2018

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET SECTION 1 - PRODUCT INFORMATION SUPERPLASTICIZER SECTION 2 - HAZARD IDENTIFICATION

MSA GLC 5 Effective Date: 03/21/05

Material Safety Data Sheet

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Page 1 of 6 MSDS # Date Issued: 18Jun1997 Supersedes: 13Sep1996

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Transcription:

Section 1 - Chemical Product / Company Information Product Name: GLASS FLAKE Revision Date: 07/30/2014 Identification Number: ACF 100, ACF 200, ACF300 Supersedes: 07/30/2007 Product Use/Class: FOR INDUSTRIAL USE ONLY Preparer: Regulatory, Department Manufacturer: NAFTA 3207.40.02 TILAB LTD. 325 W. Main St. Newark, Ohio 43055 Section 2 - Composition / Information on Ingredients Chemical Name CAS Number Weight % Less Than/ ACGIH TLV-TWA/ ACGIH TLV-STEL/ OSHA PEL-TWA/ OSHA-CEIL GLASSFLAKE 65997-17-3 100.0 NE N/E NE NE Section 3 - Hazards Identification Emergency Overview: No unusual conditions are expected from this product. Effects of Overexposure - Eye Contact: May cause eye irritation. Effects of Overexposure - Skin Contact: Skin contact with dust and fibers may produce Itching and temporary irritation. Effects of Overexposure - Inhalation: Inhalation of dusts and fibers may cause temporary Irritation of the mouth, nose and throat. Effects of Overexposure - Ingestion: Ingestion of this material is unlikely. Effects of Overexposure - Chronic Hazards: There are no known health effects associated with chronic exposure to this product. Primary Route(s) Of Entry: Skin Contact, Inhalation, Eye Contact Medical Conditions Prone to Aggravation by Exposure: Chronic respiratory or skin conditions that are aggravated by mechanical irritants may be at increased risk for worsening from exposure to this product. Section 4 First- Aid Measures First Aid - Eye Contact: Flush eyes with running water for at least 15 minutes. Seek medical attention if irritation persists. First Aid - Skin Contact: Wash with mild soap and running water. Use a washcloth to help remove fibers. To avoid further irritation, do not rub or scratch irritated areas. Rubbing and scratching may force fibers into skin. Seek medical attention if irritation persists. 1

First Aid - Inhalation: Move person to fresh air. Seek medical attention if irritation persists. First Aid - Ingestion: Ingestion of this material is unlikely. If it does occur, observe individual for several days to insure that intestinal blockage does not occur. Section 5 - Fire Fighting Measures Flash Point, F: None Lower Explosive Limit, %: N/A Upper Explosive Limit, %: N/A Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam, Water Fog Unusual Fire And Explosion Hazards: None known. Special Firefighting Procedures: Use a self-contained breathing apparatus (SCBA) in a sustained fire. Section 6 - Accidental Release Measures Steps To Be Taken If Material Is Released Or Spilled: LAND SPILL: Scoop up material and put into suitable container for disposal as a non-hazardous waste. WATER SPILL: This material will sink and disperse along the bottom of waterways and ponds. It cannot easily be removed after it is waterborne; however, the material is non-hazardous in water. AIR RELEASE: This material will settle out of the air. If concentrated on land it can then be scooped up for disposal as a non-hazardous waste. Section 7 - Handling and Storage Handling: No special handling procedures are required for this material. Storage: Keep container closed when not in use. Section 8 - Exposure Controls / Personal Protection Engineering Controls: General ventilation should be provided to maintain ambient concentrations below nuisance levels. Respiratory Protection: A properly fitted NIOSH/MSHA approved disposable dust respirator should be used when high dust levels are encountered; the level of glass fibers in the air exceeds the OSHA permissible limits; or if irritation occurs. Skin Protection: Loose fitting long-sleeved shirt that covers to the base of the neck, long pants, and gloves should be worn. Skin irritation is known to occur chiefly at pressure points such as around neck, wrist, waist and between fingers. 2

Eye Protection: Recommend safety glasses with side shields or chemical goggles to avoid eye contact. Other protective equipment: Eye wash and safety showers should be readily available. Hygienic Practices: Handle in accordance with good industrial hygiene and safety practices. These practices include: avoiding unnecessary exposures to dusts and fibers by using good local exhaust ventilation; removal of the material from the skin and eyes after exposure; removal of material from clothing (Use vacuum equipment to remove fibers and dusts from clothing. Compressed air should never be used. Always wash contaminated work clothes separately from other laundry and wipe out washer / sink to prevent loose fibers from getting on other articles); keep the work area clean of dusts and fibers generated during fabrication (Use vacuum equipment to clean up dusts and fibers. Avoid sweeping or using compressed air as these techniques re-suspend dusts and fibers into the air.) and; have access to safety showers and eye wash stations. Section 9 - Physical and Chemical Properties Boiling Range: N/A -. Vapor Density: N/A Odor: None Odor Threshold: N/D Appearance: White / Off-White colored solid Evaporation Rate: N/A Solubility in H2O: Insoluble Freeze Point: N/A Specific Gravity: 2.402 Vapor Pressure: N/A PH: N/D Physical State: Solid Section 10 - Stability and Reactivity Conditions To Avoid: Keep Dry. Material becomes hard and unusable when exposed to water. Incompatibility: None Hazardous Decomposition Products: Sizings or binders may decompose in a fire. Hazardous Polymerization: Will not occur under normal conditions. Stability: This product is stable under normal storage conditions. 3

Section 11 - Toxicological Information Product LD50: N/D Product LC50: N/D Chemical Name CAS Number LD50 LC50 GLASSFLAKE 65997-17-3 NOT AVAILABLE NOT AVAILABLE Section 12 - Ecological Information Ecological Information: No data Section 13 - Disposal Information Disposal Information: RCRA HAZARDS CLASS: Non Hazardous Material. Take up material and seal tightly for proper disposal. Section 14 - Transportation Information DOT Proper Shipping Not Regulated Packing N/A Name: Group: DOT Technical Name: N/A Hazard N/A Hazard Subclass: None Subclass: N/A DOT Hazard Class: None Resp. Guide N/A Page: N/A DOT UN/NA Number: None Additional Notes: None. Section 15 - Regulatory Information CERCLA - SARA HAZARD CATEGORY This product has been reviewed according to the EPA Hazard Categories promulgated under Sections 311and 312 of the Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to meet the following categories: SARA SECTION 313 This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372: No Section 313 Substances exist in this product 4

TOXIC SUBSTANCES CONTROL ACT All components of this product are listed on the TSCA inventory. This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported from the United States: No TSCA 12(B) Substances exist in this product U.S. STATE REGULATIONS AS FOLLOWS: NEW JERSEY RIGHT-TO-KNOW The following materials are non-hazardous, but are among the top five components in this product. NONE PENNSYLVANIA RIGHT-TO-KNOW The following non-hazardous ingredients are present in the product at greater than 3%. NONE CALIFORNIA PROPOSITION 65 Warning: The following ingredients present in the product are known to the state of California to cause cancer, birth defects, or other reproductive hazards: No California Proposition 65 Cancer or Reproductive Toxins exist INTERNATIONAL REGULATIONS AS FOLLOWS: CANADIAN WHMIS This MSDS has been prepared in compliance with Controlled Product Regulations except for the use of the 16 headings. CANADIAN WHMIS CLASS: No WHMIS Class Assigned Section 16 - Other Information HMIS Ratings Health: 1 Flammability: 0 Reactivity: 0 Personal Protection: X VOLATILE ORGANIC COMPOUNDS, GR/LTR MIXED (UNTHINNED): Refer to Part A MSDS REASON FOR REVISION: This version replaces previous version dated 10/12/2006. Changes Modified to new format Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined NOTICE TO READER The information contained herein is, to the best of our knowledge and belief accurate. However, since the conditions of handling and use are beyond our control, we make no guarantee of results, and assume no liability for damages incurred by use of this material. It is the responsibility of the 5

user to comply with all applicable federal, state, and local laws and regulations 6