SAFETY DATA SHEET 1. IDENTIFICATION OF THE SUBSTANCE AND COMPANY Product Name Company Name Address DR. SMARTH DENTURE ADHESIVE CREAM UMENDRA EXPORTS PVT LTD Emergency Tel +91 11 26234510 1102, Devika Tower, 6, Nehru Place, New Delhi India 110019 Recommended Use Before fitting dentures or applying any Fixodent denture adhesive, please ensure your dentures are clean and thoroughly dry 2. COMPOSITION/INFORMATION ON INGREDIENTS INGREDIENTS PERCENTAGE CAS NUMBER COLLOIDAL ANHYDROUS SILICA 6.0-8.0 7631-86-9 PETROLATUM 25.0-30.0 8009-03-8 LIGHT LIQUID PARAFFIN 30.0-40.0 90622-46-1 CMC 10.0-15.0 9004-32-4 GANTREZ 10.0-15.0 9067-41-8 COLOR QS NA PERFUME QS NA 3. HAZARDS IDENTIFICATION Hazard Classification NON-HAZARDOUS SUBSTANCE NON-DANGEROUS GOODS
4. FIRST AID MEASURES Inhalation Ingestion Skin Remove from contaminated area. If symptoms develop and persist seek medical attention. Do NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. If large quantities of this material are swallowed, call a physician immediately. Loosen tight clothing such as collars, ties, belts or waistbands Wash with soap and water- get medical attention if irritation occurs Eye Flush with plenty of water or eye wash solution for 15 minutes. Get medical attention if irritation persists 5. FIRE FIGHTING MEASURES Extinguishing Media Explosion Hazards Special Instructions Use appropriate fire extinguisher for surrounding Environment Noncombustible None 6. ACCIDENTAL RELEASE MEASURES Emergency Procedures If possible contain the spill. Wipe up with soap and water. Area may be slipper take precautions.
7. HANDLING AND STORAGE As with all chemicals, good industrial hygiene practices should be followed when handling this material. Avoid freezing or excessive heat. Do not handle or Store near an open flame, heat or other sources of ignition. Keep the container tightly closed and in a cool, well-ventilated place. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION This section only applies to the product when used in an industrial setting. Ventilation Good general ventilation is sufficient for control. Eye Protection Wear safety glasses with side shields. Respiratory Protection None Skin Protection Lab Coat and gloves should be worn 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance/Color Colored continuous mass Odor Characteristic ph Value 5.0-9.0 Melting Point Boiling Point Solubility in Water Soluble Specific Gravity 0.90 1.20 Vapour Pressure Vapour Density Flash point Other data
10. STABILITY AND REACTIVITY Stability Conditions to avoid Incompatible Materials Hazardous Decomposition Products Stable under normal conditions of use. Extremes of temperature. Reactive with strong oxidizing agent 11. TOXICOLOGICAL INFORMATION Chronic effects Target organs Carcinogenicity Skin Eye No chronic health effects reported. No target organs reported. This finished consumer product is not carcinogenic. May cause redness, itching and irritation. May cause eye irritation, tearing, stinging, blurred vision, and redness. 12. ECOLOGICAL INFORMATION Ecotoxicity No ecological data available for this product. Persistence/ Degradability Mobility Environ. Protection This product is intended for dispersive use and should not be disposed of directly into the environment.
13. DISPOSAL CONSIDERATIONS Disposal Considerations Dispose of waste according to applicable State/Provincial and Local regulations. 14. TRANSPORT INFORMATION Transport Information Transportation by Ground Transportation by Sea Transportation by Air Not classified as a Dangerous Good. 15. REGULATORY INFORMATION The product described in this Material Safety Data Sheet is regulated under the European COUNCIL DIRECTIVE of 27 July 1976 on the approximation of the laws of the Member States relating to cosmetic products (76/768/EEC) and is safe to use as per directions on container and box. 16. OTHER INFORMATION Date of preparation or last revision of May 2017 MSDS